Rockwell Automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATION Fieldbus Linking Device - Manual (Page 61)

Rockwell Automation Publication 1788-UM057B-EN-P - September 2014 59
Diagnostics Chapter 4
Device Type Manager (DTM) Use the HSThinFrame to open the device DTM in the Studio 5000 Logix
Designer application. The DTM is read-only when opened in the Studio 5000
Logix Designer application.
Follow these steps to open the DTM.
1. Click Advanced in the config tree.
2. Choose the DD revision from the pull-down list.
3. Click Open DTM.
4. Choose the device information that you want to view.
IMPORTANT The correct DTM must be installed and the HSProcessUtility DTM Catalog must
be updated for the correct DTM to display in the pull-down list.