Rockwell Automation 1788-CN2FFR EtherNet/IP and ControlNet to FOUNDATION Fieldbus Linking Device - Manual (Page 26)

24 Rockwell Automation Publication 1788-UM057B-EN-P - September 2014
Chapter 2 Set Up in the Studio 5000 Logix Designer Application
3. Select the communication path to the ControlNet network, select the
ControlNet port, and click OK.
The following pop-up window appears while RSNetWorx browses the
network.
Once complete, all devices on the network are displayed in the graphic
window on the right side of the window.
4. Right-click any white space around the graphics and select Enable Edits.
5. Right-click any white space around the graphics and select Properties.