Rockwell Automation 1769-SM1 Compact I/O to DPI/SCANport Module - Manual (Page 22)

2-2 Installing the Module
For detailed information on both configuration modes, please refer to
Controller Mode on page 3-2 or Parameter Mode on page 3-13 . Then set
the module Configuration Mode switch ( Figure 2.1 ).
Figure 2.1 Setting the Configuration Mode Switch
Removing Power
!
ATTENTION: Risk of equipment damage exists. Remove power
before installing or removing the 1769-SM1 module. When you install
or remove the module with power applied, an electrical arc may occur.
An electrical arc can cause personal injury or equipment damage by:
• Sending an erroneous signal to your system’s field devices, causing
unintended machine motion.
• Causing an explosion in a hazardous environment.
Electrical arcing causes excessive wear to contacts on both the module
and its mating connector. Worn contacts may create electrical
resistance.
Selecting the Configuration Mode
Switch Setting Description
Controller
(Default) 1769-SM1 uses the configuration data downloaded from the controller
on power-up and when the controller is placed in run mode.
Parameter 1769-SM1 uses its internal parameter setting to configure the module.
CONT
Position
PARAM
Position
Unused
Switch
CONT
Position
PARAM
Position
Unused
Switch