Rockwell Automation 1769-SM1 Compact I/O to DPI/SCANport Module - Manual (Page 38)

3-8 Configuring the Module
3. Click on the Chan. 1 tab ( Figure 3.6 ) and set the I/O Config data
area accordingly. In this example, Cmd/Ref and all Datalinks are
used.
Figure 3.6 Chan. 1 Tab Data Screen
Select the desired Idle Action. Note that the Fault Config Data area
(
Figure 3.7 ) can only be accessed if Send Flt Cfg is enabled.
Figure 3.7 Chan. 1 Tab Data Screen with Idle Action - Send Flt Cfg Enabled
4. For each additional channel being used, select its respective tab, set
the desired I/O configuration, and enable the appropriate idle action.