Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual - Manual (Page 119)

Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
111
Appendix
B
Troubleshooting
Status Indicators on the
Controller Status indication on the Micro820 controller is as follows.
Status Indicator Description
Description State Indicates
1 Input status Off Input is low.
On Input is energized (terminal status).
2 Fault status Off No fault detected.
Red Controller hard fault.
Flashing red Major fault detected.
3 Run status Green Executing the user program in run mode.
Flashing Green (1 Hz) The controller is in program mode.
4 Serial
communications
status
Off No traffic for RS232/RS485.
Green Traffic through RS232/RS485.
5 Force status Off No force conditions are active.
Amber Force conditions are active.
Input status
Run status Fault status
Force status Comm status
ENET status SD status
Output status
46207