Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual - Manual (Page 136)

128 Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
Appendix C Quickstarts
9. Click Finish to complete.
Configure Controller
Password Set, change, and clear the password on a target controller through the Connected
Components Workbench software.
IMPORTANT
The following instructions are supported on Connected Components
Workbench revision 2 and Micro800 controllers with firmware revision 2.
For more information about the controller password feature on Micro800
controllers, see
Controller Security on page 57 .