Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual - Manual (Page 56)

48 Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
Chapter 5 Communication Connections
Configure Ethernet Settings 1. Open your Connected Components Workbench project (for example,
Micro820). On the device configuration tree, go to Controller properties.
Click Ethernet.
2. Under Ethernet, click Internet Protocol.
Configure Internet Protocol (IP) settings. Specify whether to obtain the
IP address automatically using DHCP or manually configure IP address,
subnet mask, and gateway address.
3. Click the checkbox Detect duplicate IP address to enable detection of
duplicate address.
4. Under Ethernet, click Port Settings.
5. Set Port State as Enabled or Disabled.
6. To manually set connection speed and duplexity, uncheck the option box
Auto-Negotiate speed and duplexity. Then, set Speed (10 or 100 Mbps)
and Duplexity (Half or Full) values.
TIP
The Ethernet port defaults to the following out-of-the box settings:
• DHCP (dynamic IP address)
• Address Duplicate Detection: On