Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 90
82
Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
Chapter 9
Using microSD Cards
IMPORTANT
Datalog Function Block Execution
•
There are three possible states for the Datalog function block: Idle,
Busy and Complete (which includes Complete with Succeed and
Complete with Error).
•
For one Datalog function block execution, the typical status starts
from Idle, then Busy and finishes with Complete. To trigger another
function block execution, the status needs to go back to Idle first.
•
Idle status changes to Busy status only when Enable input signal is in
rising edge. Complete status enters Idle status when Enable input
signal is Disable status only.
•
TSEnable and CfgId input parameters are only sampled at Enable
input parameter's rising edge when a new function block execution
starts. During function block execution, the input parameters of
TSEnable and CfgId are locked and any changes are ignored.
•
When execution completes, the status changes from Busy to
Complete. At this stage, if input Enable is False, status changes to
Idle after indicating Complete for exactly one scan time. Otherwise
function block status is kept as Complete until input Enable changes
to False.
•
The datalog file can only be created by the DLG instruction block.
Connected Components Workbench can only upload and delete the
datalog file.
•
There are separators in between every data variable in the data file
which is defined during configuration in Connected Components
Workbench.
Supported Data Types for Datalog and Recipe Function Blocks on
.
•
Data variable values are sampled when datalogging function block is
in Busy state. However, datalogging file is only created when
datalogging function block is in Complete state.
Supported Data Types for Datalog and Recipe Function Blocks
Data Type
Description
Example format in output
datalog file
BOOL
(1)
Logical Boolean with
values TRUE and FALSE
0: FALSE
1: TRUE)
SINT
Signed 8-bit integer value -128, 127
INT
Signed 16-bit integer
value
-32768, 32767
DINT
Signed 32-bit integer
value
-2147483648, 2147483647
LINT
Signed 64-bit integer
value
-9223372036854775808, 9223372036854775807
USINT(BYTE)
Unsigned 8-bit integer
value
0, 255
UINT(WORD)
Unsigned 16-bit integer
value
0, 65535
UDINT(DWORD) Unsigned 32-bit integer
value
0, 4294967295
ULINT(LWORD)
Unsigned 64-bit integer
value
0, 18446744073709551615