Rockwell Automation 2098-IPD-020-DN Ultra5000 Series Intelligent Positioning Drives with DeviceNet Reference Manual - Manual (Page 14)

Publication 2098-RM002A-EN-P – October 2001
1-6 The DeviceNet Interface
Figure 1.7
Data Rate Rotary Switch
4. Apply power to the drive.
5. Observe the module status LED.
6. Observe the network status LED.
If the module status LED: Then:
Is not steady green Refer to Troubleshooting DeviceNet Drives
on page 5-1.
Is steady green The drive is ready. Go to step 6.
If the network status LED: Then:
Is off Establishing communication with
network (wait for flashing or
steady green).
Is not flashing or steady green Refer to Troubleshooting
DeviceNet Drives on page 5-1.
Is flashing or steady green Communication is ready. Go to
Chapter 2.
Use the Data Rate rotary switch on the DeviceNet
panel of the drive to set the data rate.