Rockwell Automation 9303 DRIVE TOOLS32 GETTING STARTED - Manual (Page 49)

Setting Up DH+ Direct Communications Systems 4-7
Publication 9303-5.13 – March 1998
4. Verify the information is correct.
Important: In the Comm Port field, you must enter the number of the Comm
Port with which you intend to use DriveTooles32.
Important: In the Station Number field, you must enter the station number that
matches the GD2 module’s address.
5. Click OK.
Testing the Configured Driver
To test the configured driver, you need to:
1. Close the Configure Drivers dialog box.
2. From the Communications menu, select SuperWho.
If you have only one configured driver, the communication between the
node(s) on the network should be displayed.