Rockwell Automation 9303 DRIVE TOOLS32 GETTING STARTED - Manual (Page 76)

7-4 Setting Up an Allen-Bradley Ethernet to RIO Block Transfer Pass Thru Communications System
Publication 9303-5.13 – March 1998
3. Double-click Ethernet to PLC5 or 5820-El. The Configure Ethernet-to-
AB Communications dialog box appears.
4. In the Driver Station field, enter a unique station number for your PC on
the Ethernet. Valid numbers are from 0 to 63.
5. In the IP Address or hostname field, enter the IP address.
Remember the IP address. You will enter it again in the Communications
Setup dialog box.
6. In Current Mappings, select an available Mapping.
7. Click Accept.
8. Click OK.
Testing the Configured Driver
To test the configured driver, you need to:
1. Close the Configure Drivers dialog box.