Rockwell Automation 9303 DRIVE TOOLS32 GETTING STARTED - Manual (Page 59)

Setting Up a DH+ to RIO Block Transfer Pass Thru Communications System 5-5
Publication 9303-5.13 – March 1998
Mapping the Configured Driver(s) to the KTPort Value
To map the configured driver(s) to the KTPort value, you need to:
1. From the Communications menu, select Configure Client Applications.
The Configure Client Applications dialog box appears.
2. Choose an unused KT:0 field to map the DH+ device to.
Important: When you use the Communication Setup option from within any
of the DriveTools32 applications, you need to enter the RSLinx KT:0 number
(i.e., 1 – 8) to which you just mapped the DH+ device. Enter the number in the
Enter mapping KT(X) Port # to use field in the Communication Setup dialog
box.
3. Use the field’s drop box to map the configured driver to the port.
4. Click OK or Apply.
Important: When using RIO Block Transfer Pass Thru for drive
communications from the PC, you cannot use Block Transfer messages in the
PLC program for this drive.