Rockwell Automation 2080-LC50 Micro830 and Micro850 Programmable Controllers User Manual - Manual (Page 80)

66 Rockwell Automation Publication 2080-UM002F-EN-E - December 2013
Chapter 7 Motion Control with PTO and PWM
Sample Motion Wiring Configuration on 2080-LC30-xxQVB/2080-LC50-xxQVB
2080-L
C30-xxQVB
2080-L
C50-xxQVB
K
inetix3
+DC 24
-DC 24
+CM0
+CM1
O-00
O-03
O-06
O-07
-CM0
-CM1
Pin 1, 2
Pin 49(CLK+)
Pin 12(CLK-)
Pin25(DIR+)
Pin 14(DIR-)
Pin 3(Enable)
Pin 7(RST)
1 2
24V
Power
Supply
–
_
Enc
oder
Mot
or
Encoder signal cable
Motor power cable
+ +
24V
Power
Supply
To help you configure Kinetix3 drive parameters so the drive can communicate and be controlled
by a Micro830/Micro850 controller, see publication
CC-QS025 .
46056
Notes:
(1) Drive Enable (Pin 3) and Reset Drive (Pin 7) will be operating as sourcing inputs when (Pin1,2)
connected to – of the Power Supply 2.