Rockwell Automation 2706-LV2P_LV2R_LV4P_LV4R DL40 PLUS USER MANUAL - Manual (Page 154)

DIP Switch Settings 10–10
Publication 2706-6.1
Two DIP switch banks are located on the back of the module. You
can access the DIP switches through a cutout, as shown below.
KEYBOARD
SW1
SW2
GND
RELAY
L1 L2N
RS-485
250 VAC 3A
12VDC
RS-232
Parallel Port Version
DIP Switches
Switch Bank #1 (SW–1) controls: Debug Mode, Fast Reset
Sequence, Keyboard Type, Select Enable.
Switch Bank #2 (SW–2) sets the serial address. The serial address
refers to the address used for triggers received from the serial
RS-485 port or computer keyboard.
Important: Remove power from The DL40 Plus before setting any
switch except Select Enable, SW1–9. Select Enable can be changed
with the power ON. Switch settings are scanned only on power-up.
The new setting for Select Enable takes effect immediately. The new
settings for all other switches take effect when you power-up or reset
the DL40 Plus.
DIP Switches on
Parallel Port Versions