Rockwell Automation 2706-LV2P_LV2R_LV4P_LV4R DL40 PLUS USER MANUAL - Manual (Page 43)

Using the Onboard Editor to Create Messages 2–17
Publication 2706-6.1
Newest Message on Line 1
This option displays the newest message to be triggered on line 1 and
shifts previously triggered messages down. The message on the
bottom line is shifted off the display. This supersedes the message
attribute Message on Line # Only (messages are still displayed in 20
character segments). This attribute is compatible with all Run modes.
Type [Y][
↵ ] to activate or [N][
↵
] to deactivate.
Autorun Message Number
The autorun message is a message that displays when your DL40
Plus is powered up or anytime run mode is entered. It can be any
message including a message in the Message List.
Specify a message number (a value of 0 deactivates the autorun
message).
Note: If Remote I/O communications between a DL40 Plus and a
PLC are not established at power-up, the autorun message runs only
if switch 8 on Switch Bank #2 (Last State) is ON.
Background Message Number
The background message runs for a minimum of 2 seconds after the
last triggered message has finished its display wait time. The
background message is displayed until a valid message is triggered
or until Run mode is exited. The background message does not
support variable data.
Specify a message number (a value of 0 deactivates Background
Message).
Note: If Remote I/O communications between a DL40 Plus and PLC
are inactive or faulted, the Background Message runs only if switch
8 on Switch Bank #2 (Last State) is ON.