Rockwell Automation 2706-LV2P_LV2R_LV4P_LV4R DL40 PLUS USER MANUAL - Manual (Page 64)

Offline Operating Modes 4–11
Publication 2706-6.1
Print mode lets you print the list of Message Numbers and text in the
DL40 Plus’s internal application memory and/or the current settings
for all parameters. You can only enter Print mode from Run mode.
Entering Print Mode from a Keyboard
To enter Print mode from a keyboard, press [CTRL] [P] using a
keyboard. You can print messages and/or parameters.
Press [Y] or [N] followed by [
↵
] for each prompt.
Entering Print Mode from the Front Panel
To enter Print mode from the front panel, press the [SELECT] and
[
↵
] push buttons. You can print messages and parameters.
Press [SELECT] or [
↵
] for each prompt. Select corresponds to No;
Enter corresponds to Yes. If you enter [N] to return to Run Mode, the
DL40 Plus goes back to the first prompt. Pressing [ESC] or [MSG
ACK] returns you to Run mode. Pressing [ESC] or [MSG ACK] while
printing returns you to Print mode prompts. If the DL40 Plus is
performing a print function, that function will be aborted.
Debug mode is only available on the Parallel port version of the
DL40 Plus. It allows you to monitor the current state of all of the
parallel port inputs.
The 3 ways to enter Debug mode are:
•
Power up the DL40 Plus with the Debug/Run mode DIP switch in
the Debug position. To return to Run mode, set the DIP switch to
the Run position and reset the unit.
•
Press [CTRL] [D ] on a keyboard when the unit is in Run mode.
Press any key on the keyboard to return to Run mode.
•
Press the [
↵
] and [SELECT] push buttons on the front panel of the
DL40 Plus. To return to Run mode, press the [
↵
] and [SELECT]
push buttons again.
The display will have the following format in this mode:
Print Mode
Debug Mode