Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 53)

Publication CNET-IN003A-EN-P - January 2006
Install a ControlNet Ex Media System 3-11
Connect the Fiber Repeater Hub to a ControlNet Ex Network
1. Connect to the ControlNet Ex coax network with the drop line
of the Ex coax tap to the adapter BNC connector.
2. Connect the fiber media to the fiber module by attaching the
receive and transmit fibers to either the left or right set of receive
and transmit ports.
3. Attach the opposite ends of the cable to the other fiber module.
.
IMPORTANT
Make note of which fiber is receive and which is
transmit. These fibers must be interchanged at the
opposite end of the cable.
ATTENTION
Use the blue intrinsically-safe insulators on all coax
BNC drop connectors as they are installed.
41170
Intrinsically-safe
Insulator
1
.
.
.
.
1 2 4 3 +V -V +V -V
Q UAL IT Y
B - A Allen-Bradley 1797 - RPA
ControlNet E x REPEATER ADAPTER Comm
Status Module
Status
PWR
.
.
.
Recv Xmit Recv Xmit
Chan 2 Chan 1
1797 - RPFM Q UAL I TY B - A Allen-Bradley
ControlNet E x FIBER MODULE MEDIUM RANGE
.
1
.
.
.
.
1 2 4 3 +V -V +V -V
Q UAL IT Y
B - A Allen-Bradley 1797 - RPA
ControlNet E x REPEATER ADAPTER Comm
Status Module
Status
PWR
.
.
.
Recv Xmit Recv Xmit
Chan 2 Chan 1
1797 - RPFM Q UAL I TY B - A Allen-Bradley
ControlNet E x FIBER MODULE MEDIUM RANGE
.
Receive
Transmit
Transmit
Receive
4131