Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 62)

Publication CNET-IN003A-EN-P - January 2006
3-20 Install a ControlNet Ex Media System
Attach the Connectors to the Cable
1. Push the calibration/flare tool onto the cable and with a slight
twisting motion (with sufficient inward pressure) to expand the
braid.
IMPORTANT
Replace the trunk cable section if problems persist
with the cable after completing these tests.
41888
41890
Push the calibration/flare tool gently and
rotate slightly onto the connector while
you apply pressure. This will work the
base of the connector underneath
the wire braid slowly.