Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 79)

Publication CNET-IN003A-EN-P - January 2006
Adjust the Cable Strip Tool B-5
Change the Memory Blade
Holder You received two memory blade holders with your cable strip tool;
one is for PVC-CL2 cable, and the other is for plenum FEP-CL2P cable.
You need to install the appropriate memory blade holder for the type
of cable you are stripping (PVC or FEP).
1. Lift the latches on the memory blade holder and swing it back.
2. Snap the memory blade holder off the rod and
remove it from the strip tool.
3. Position the appropriate memory blade holder on the rod and
snap the holder into place.
4. Swing the memory blade holder closed.
20182-m
20070-m
20069-m