Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 75)

1 Publication CNET-IN003A-EN-P - January 2006
Appendix
B
Adjust the Cable Strip Tool
What This Appendix
Contains Follow the instructions in this appendix to calibrate the cable strip tool
supplied with the ControlNet Coax Toolkit (1786-CTK).
Calibrate the Cutting
Blades Use the following procedure to calibrate your cable strip tool to cut
FEP or PVC cable.
1. Turn the three screws outward to back the blades out. This
prevents the calibration tool from bottoming out.
2. Place the calibration tool into the cable strip tool with the
narrow end installed and facing forward for FEP cable (use the
wider end for PVC).
3. Tighten the chamber gauge ring so that the calibration tool is
locked in place.
4. Continue tightening all the way to the chamber gauge stop.
When aligned properly, the grooves of the calibration tool
should align with the blades.
5. Adjust the screws of the memory clip so that the blades just
touch the calibration tool.
2088-m
Adjusting Screws To Turn The Screw
Increase the cut depth Clockwise
Decrease the cut depth Counterclockwise
41892
FEP
PVC
Calibration Tool
ATTENTION
Do not over-tighten the screws of the cable strip
tool. The blades should not bend, shift, or penetrate
the calibration tool.