Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual - Manual (Page 57)

Publication CNET-IN003A-EN-P - January 2006
Install a ControlNet Ex Media System 3-15
4. Lock the cable into place by moving the chamber-gauge ring
forward until it meets the cable with slight resistance.
5. Hold the cable in one hand, place the index finger of your other
hand inside the chamber-gauge ring and turn the strip tool 360°
around the cable. Turn four or five full rotations until the strip
tool glides easily around the cable.
IMPORTANT
The last time you repeat steps 4 and 5, apply
sufficient pressure on the chamber-gauge ring to be
certain the ring has reached the last stage. The
chamber gauge reads ‘stop’ for the last repetition.
This gauge moves two rollers toward the cable and regulates the
depth of the cut.
The gauge will click as it moves from one gauge to the next.
20073
Repeat steps 4 and 5, moving the chamber-gauge ring forward one notch
for each time you repeat the steps, until you reach the last notch.
Each Time you move the chamber-gauge ring forward a notch, the strip
tool makes a deeper cut into the cable.
20074