Reverse and replace the cutting blades – Rockwell Automation 1797-Series ControlNet Ex Media Plannng Installation Manual User Manual
Page 77
Advertising
Publication CNET-IN003A-EN-P - January 2006
Adjust the Cable Strip Tool B-3
Reverse and Replace the
Cutting Blades
To reverse or change the cutting blades:
1. Use a screwdriver to lift the memory blade holder and swing it
back.
2. Slide the memory blade cartridge out of the strip tool.
3. Flip the memory blade cartridge and slide it back into the strip
tool.
20182-m
20183-m
If You Are
Go To
Reversing the memory blade cartridge
to use the second set of blades
The next step
Replacing the memory blade cartridge Step 4
Advertising