Rockwell Automation FactoryTalk Report Expert User Guide - Manual (Page 125)

Editing Event and Production Data Chapter 8
Rockwell Automation Publication RPTEXP-UM001H-EN-P-June 2014 125
To delete an event:
1. Select the Edit Events operation and the desired parameter
set, and then click View Data.
TIP
Alternatively, select the Enter Data Manually operation and
the desired parameter set, and then click View Data. In the
Select Area and Shift Details panel, click Events.
The data is displayed in the Event list panel.
2. Under Actions, click More > Delete in the row with the event
that you want to delete.
NOTE
The Delete option is not displayed if the event configuration
restrictions are not fulfilled.
3. Click OK to confirm that you want to delete the selected
event.
You can edit the following production data:
• The number of good and scrap parts (page 125).
• The ID of the part produced (page 126).
• The ideal cycle time (page 127).
• The values of user-defined summarization fields (page 127).
To edit the number of good and scrap parts:
1. Select the Edit Production Data operation and the desired
parameter set, and then click View Data.
TIP
Alternatively, select the Enter Data Manually operation and
the desired parameter set, and then click View Data. Make sure
that the Production option is selected.
The data is displayed in the Production data list panel.
2. Make sure the Lock part counts at their current times...
check box under Options is cleared. Otherwise, you will not
be able to edit the number of good and scrap parts.
Editing Production Data
Editing the Number of Good
and Scrap Parts