Rockwell Automation FactoryTalk Report Expert User Guide - Manual (Page 80)

Chapter 6 Understanding Parameter Sets
80 Rockwell Automation Publication RPTEXP-UM001H-EN-P-June 2014
Click this button: To:
[up arrow] for the next minute, [down arrow] for the previous
minute, [page up] for the next hour, [page down] for the previous
hour.
If you do not specify a start time, 0:00:00 a.m. (midnight) is used. If
you do not specify an end time, 0:00:00 a.m. (midnight) of the next
day is used. For example, if you select 1/12/2008, Report Expert
uses 2/12/2008 0:00:00 a.m.
You can type an end date/time that is in the future.
Specify Time
Span Ending Now
Specify that you want to view all information that was recorded
during a specified time interval (in the past) through the current
date and time.
You must specify a time interval:
In the first Past field you must specify a number and in the second
Past field you must type a time value (in seconds, minutes, and so
on). Together, these two fields specify the length of the time
interval.
Specifying the time span can be useful for saved parameter sets
because the time span always applies. For example, the past 24
hours is always a valid time filter.
Specify Time
Span Ending on End
Date
Specify that you want to view all information that was recorded
during a specified time interval (in the past) through a specified
end date and time.
To specify the required time interval, in the first Past field, type a
number; then click the drop-down arrow to select a time value
(seconds, minutes, and so on). Together, these two fields specify
the length of the time interval. You must also complete the End
date field and the End time field.
The Past field must specify a number and the Past list must contain
a time value (seconds, minutes, and so on). Together, these two
fields specify the length of the time interval.
The End date field must specify a date with the following format:
MM/DD/YYYY, where leading 0s in the month and day are optional