Rockwell Automation DeviceLogix System User Manual - Manual (Page 106)

106 Publication RA-UM003B-EN-P - February 2010
Chapter 4 Navigate the Old Ladder Editor Interface
Configuration Toolbars The old Ladder Editor toolbars are:
• Standard - Lets you perform general editing functions, verify
logic, and toggle edit mode.
• Ladder Element - Lets you add ladder elements to the old Ladder
Editor. The toolbar changes based on the element you are
adding (bit, latch, timer, or counter). You can drag and drop
elements from this toolbar into the old Ladder Editor.
• Online - Lets you perform online functions. This toolbar is
enabled only when you are working on line.
Standard Toolbar
Standard Toolbar
Function Description
Sends the ladder logic to a printer.
Removes the selected ladder element.
Duplicates the selected content to save it in the clipboard.
Removes the saved content in the clipboard and puts the
content in the old Ladder Editor where your cursor is resting.
Cancels the last action.
Performs again the previously cancelled action.
Increases (make larger) the view of the configuration. You
lose view of part of the configuration pane of the old Ladder
Editor when you use this function.
Decreases (make smaller) the view of the configuration. You
see more of the configuration pane of the old Ladder Editor
when you use this function.
Confirms that the logic that you configured is valid.
Toggles between working in the Edit mode and not working
in the Edit mode. In the Edit mode, you can make changes to
the Logic. You must exit the Edit mode to download the logic
to the device.