Rockwell Automation DeviceLogix System User Manual - Manual (Page 84)

84 Publication RA-UM003B-EN-P - February 2010
Chapter 3 Bind Function Blocks with I/O
4. Once the upload or download is completed, click the Start
Logic Editor button.
You see:
• The local logic resident in the device
• The real-time status of the inputs and outputs indicated by data
on the connecting wires.
• Logic Enabled or Logic Disabled displayed in the online toolbar,
depending on the state of the device. You can change the state
by simply selecting the desired state.
• The word Animated displayed in the status bar, which indicates
that the logic on the screen matches the logic in the device. If
you do not see Animated and you want the logic on the screen
to match the logic in the device, you must perform an upload or
download to synchronize the logic.
5. Double-click on an element. Then select the Parameter tab to
view the updating parameter values.
Change Function Block Attribute Values
Many function blocks have attributes that can be modified online. For
example you can change Timer block’s Preset (PRE) and Accumulator
(ACC) while the logic is running. See the following figure.