Rockwell Automation DeviceLogix System User Manual - Manual (Page 113)

Publication RA-UM003B-EN-P - February 2010 113
Navigate the Old Ladder Editor Interface Chapter 4
View Menu
The View menu lets you modify your view of the old Ladder Editor.
Edit Element Modifies the selected ladder element. It is possible to
change the instruction type or the instruction type
parameters. Note that it is possible to change only
instruction types of the same category (bits, latch, timers,
counters).
Edit Element Comment Modifies the comment attached to the selected rung or
instruction type. Note that you cannot add comments to
branch or branch level elements.
Properties Access the Configuration Properties dialog to modify or add
configuration information.
Recovery Mode Accesses the Recovery Mode dialog to select between
having logic enabled or disabled following the restoration of
a configuration. The Recovery Mode is used in conjunction
with the Auto Device Replace Configuration Recovery
feature.
View Menu
Function Description
Status Bar Toggles between displaying and not displaying the status
bar at the bottom of the old Ladder Editor.
Zoom In Increases (make larger) the view of the configuration. You
lose view of part of the configuration pane of the old Ladder
Editor when you use this function.
Zoom Out Decrease (make smaller) the view of the configuration. You
see more of the configuration pane of the old Ladder Editor
when you use this function.
Zoom to 100% Causes the configuration pane to mirror what is seen on the
printed version when the configuration pane is printed.
Edit Menu
Function Description