Rockwell Automation DeviceLogix System User Manual - Manual (Page 52)

52 Publication RA-UM003B-EN-P - February 2010
Chapter 2 Navigate the Function Block Editor Interface
Configuration Toolbars The Function Block Editor toolbars are:
• Standard - Lets you perform general editing functions, verify
logic, and toggle edit mode.
• Tabbed Instruction - Lets you enter Boolean or Analog type I/O,
and add functional elements to the schematic.
• Online - Lets you perform online functions. This toolbar is
enabled only when you are working on line.
Standard Toolbar
Standard Toolbar
Function Description
Sends the logic schematic to a printer.
Removes the selected element.
Duplicates the selected element and send it to the
clipboard.
Places the element in the clipboard at current cursor
position.
Verifies the logic you have configured on the schematic
sheet.
Makes the configuration smaller.
Makes the configuration bigger.
Toggles between the DeviceLogix Function Block Editor
software being in the Edit mode or not being in the Edit
mode. In the Edit mode, you can modify the logic but you
cannot communicate with the device. That is, you cannot
upload or download logic or turn the logic On or Off. When
you are not in Edit mode, you can perform online animation,
if the device is online. You can set the preset value, force
I/O, or accumulator value of counters or timers, and
download to a device, but you cannot modify logic.