Rockwell Automation DeviceLogix System User Manual - Manual (Page 192)

192 Publication RA-UM003B-EN-P - February 2010
Appendix B RSNetWorx for DeviceNet Software and the DeviceLogix Editors
To change the comm status override:
1. Click the current value of the Comm Status Override parameter.
The field turns into a drop-down list box.
2. Click the arrow to display the values.
3. Click the desired value.
4. Click Apply to save the new value without closing the window.
Or click OK to save the new value and to close the window.
IMPORTANT
The above information is relative only to bound outputs (i.e.,
outputs that are participating in the local logic).