Rockwell Automation DeviceLogix System User Manual - Manual (Page 119)

Publication RA-UM003B-EN-P - February 2010 119
Create Logic in the Old DeviceLogix Ladder Editor Chapter 5
Go On Line
Once you have created your logic and set up your scanlist or override
parameters, you are ready to go on line.
To go on line:
1. Click the Online icon on the RSNetWorx software toolbar. The
RSNetWorx software will browse the network.
2. When the browsing is complete, double click the
DeviceLogix-enabled device.
3. Click the DeviceLogix tab in the device properties window. You
may be asked to upload or download if you have not done so
already.
4. Once the upload or download is complete, click the Start Logic
Editor button.
You see:
• Local logic resident in the device.
• Real-time status of inputs and outputs indicated by 0s and 1s on
the connected wires.
• The value of the accumulators change based on the logic (if you
have timers and/or counters).
• Logic Enabled or Logic Disabled displayed in the online toolbar,
depending upon the state of the device.
• The word Animated displayed in the status bar, which means the
logic on the screen matches the logic in the device. If you do
not see the word Animated displayed, perform an upload or a
download to synchronize the logic.