Rockwell Automation DeviceLogix System User Manual - Manual (Page 117)

117 Publication RA-UM003B-EN-P - February 2010 117
Chapter
5
Create Logic in the Old DeviceLogix
Ladder Editor
What This Chapter Contains Read this chapter to learn how to create logic in the old DeviceLogix
Ladder Editor and about the options available to you when you work
on line.
Understanding and
Working With I/O Tags There are two kinds of I/O tags: static and dynamic.
Static tags are:
• Device Input (DIP) - physical input point of the device
• Consumed Network Bit (CNB) - network input bit
• Fault Bit (FB)- device fault bit
• Status Bit (SB) - device status bit
• Device Output (DOP) - physical output point of the device
• Produced Network Bit (PNB) - network output bit
Topic Page
Understanding and Working With I/O Tags 117
Online Operations 118
Communication with Devices 118
Go On Line 119
Online Animation 120
Change Logic 120
Change the Value of Timers and Counters 121
Enable and Disable Logic 121
Verify Logic 122
Compare Logic 123
Upload and Download Logic 123
Forcing 125
Clear Latched Hardware Faults 126
Recovery Mode 126
TIP
For more information on the tasks you can perform in the old
Ladder Logic Editor, see the Ladder Logic Editor online help.