Rockwell Automation DeviceLogix System User Manual - Manual (Page 159)

Publication RA-UM003B-EN-P - February 2010 159
Create Logic in the New Ladder Editor Chapter 7
To modify a parameter value while the device is online, complete
these steps.
1. Double-click the instruction that you want to change.
2. Select the Parameters tab.
3. Locate the value that you want to change (fields that can be
edited are white). Enter the new value in the box.
4. Click OK.
The new value takes immediate effect. If you change a preset,
remember to save the logic configuration the next time you exit the
new Ladder Editor.
Online Animation
When the logic in the new Ladder Editor is synched with the logic in
the device, the device is online, and the logic is enabled, the device
enters online animation mode.
When the device is in online animation mode, all input, output, and
parameters will update periodically. You can monitor the data in the
new Ladder Editor during online animation.
Enable and Disable Logic
Use the Logic Enable On function to notify the device to start
processing the stored logic diagram. This turns on the Logic Enable Bit
in the produced data. Once connections are complete, you can verify
the logic. To set Logic Enable On, choose
Communications > Logic Enable On.