Rockwell Automation WebPak 3000 User Guide - Manual (Page 17)

Description of the OIM Keypad, Display, and Indicators 2-7
2.2.2 Key Indicators
There are five indicators at the bottom of the screen above the keys. When is
set to KEYPAD , these indicators tell you which setting is selected by the key. If one of
the other control sources is selected, these indicators tell you the setting selected by
that control source.
In figure 2.2, the keys are set to PROGRAM and KEYPAD . Indicators are described in
table 2.4.
Table 2.4 – Key Indicators
Key Indicator Above
Possible
Indications Description
PROGRAM The OIM is in program mode.
MONITOR The OIM is in monitor mode.
(blank) The OIM is in a fault, alarm, or diagnostic menu.
FAULT The Fault Menu is displayed.
ALARM The Alarm Menu is displayed.
DIAGS The Diagnostics Menu is displayed.
TERMBLK The signals at the Regulator board terminal strip control the
drive.
NETWORK A network is controlling drive operation. Blinks when network
communication is not active.
SERIAL The drive is controlled through its serial port, typically by the
WebPak CS software.
KEYPAD The OIM keys control drive operation.