Rockwell Automation WebPak 3000 User Guide - Manual (Page 30)

4-4 WebPak 3000 OIM User Guide
4.2.3 Accessing the Parameters
Parameters are accessed through the menus. The menu paths to get to parameters
are provided:
• In appendix A of this manual.
• As part of the parameter descriptions in the software manual.
Some parameters and parameter options are only available if the appropriate option is
installed. For example,
ENCODER PPR (P.107) is only displayed if a Pulse Encoder kit is
installed. The cursor changes to a lock ( ) for parameters or options that are not
available.
If you exit program mode from a parameter entry screen, you are returned to that
screen when you come back to program mode.
Basics of Accessing a Parameter
Step 1. Select the menu that contains the parameter.
Step 2. Press . The next menu or parameter list is displayed. Repeat steps 1
and 2 for each menu until the parameter list you want is displayed.
Step 3. Move the cursor to the parameter you want to change. Press .
The parameter value entry screen is displayed. It allows you to look at or change
parameter values.
Example of Accessing the Analog I/O Parameters
Step 1. At the Main Menu, press to move the cursor ( ) to Input/Output as
shown in figure 4.5.
Step 2. Press . The Input/Output menu is displayed, as shown in figure 4.6.
Figure 4.5 – Selecting the Input/Output Menu
Figure 4.6 – Input/Output Menu
,QSXW2XWSXW
:HE3DN  0DLQ 0HQX
1HWZRUN &RPPXQLFDWLRQV
2XWHU &RQWURO /RRS 2&/
)LHOG &XUUHQW 5HJXODWRU
,QSXW2XWSXW
)UHTXHQF\ ,2
$QDORJ ,2
'LJLWDO ,2
/HYHO 'HWHFWRUV
)LHOG &XUUHQW 5HJXODWRU