Rockwell Automation WebPak 3000 User Guide - Manual (Page 56)

6-4 WebPak 3000 OIM User Guide
6.2.2 Setting the Control Source
To select the control source:
Step 1. Stop the drive if it is running.
Step 2. Press . The screen shown in figure 6.3 is displayed.
Step 3. Press or to move the cursor to the control source you want.
Step 4. Press to accept the option and return to the previous screen. The
option you accepted is displayed in the key indicator.
6.3 Using the OIM to Control the Drive
When is set to KEYPAD , you can use the OIM to control the drive. This includes
running, jogging, and stopping the drive.
6.3.1 Starting the Drive
From the OIM , you can run or jog the motor when is set to KEYPAD and the Drive
Ready indicator is on.
To Run the Drive:
Press to start the motor and allow it to accelerate to the drive
reference.
Figure 6.3 – CONTROL SOURCE SELECT Screen
!
ATTENTION: If the drive is ready and is set to KEYPAD , pressing
or on the OIM immediately starts the motor. Make sure the
motor and driven machinery are safe to start before pressing either of
these keys. Failure to observe this precaution could result in severe bodily
injury or loss of life.