Rockwell Automation WebPak 3000 User Guide - Manual (Page 65)

Troubleshooting the Drive Using the OIM 7-7
7.4 Clearing a Programming Error Message
Programming errors occur if you select an option that is not valid, such as attempting
to set a read-only parameter. These errors do not affect drive operation and are not
logged. To remove a programming error message, press .
7.5 Determining Why the OIM is Not Communicating
with the Drive
The OIM can stop communicating with the drive if the communication link is faulty, if a
fatal OIM error occurs, or if a fatal regulator error occurs. If one of these conditions is
present, the OIM displays a message indicating the problem.
Unless is set to OIM , an OIM failure does not affect drive operation. If the OIM is
the control source, an OIM failure causes the drive to stop.
Possible causes and solutions are shown in table 7.3.
!
ATTENTION: is not active if a communication between the drive
and OIM has stopped. Use another control source to stop the drive.
Failure to observe this precaution could result in severe bodily injury or
loss of life.
Table 7.3 – OIM Failure Causes and Solutions
Error Cause Solution
Link Failure Communication between the OIM
and Regulator board is lost. This
can occur if the cable between
them is disconnected.
Check the cable between the OIM and the
Regulator board.
The OIM attempts to re-establish
communication. If it succeeds, the message
“Press
CANCEL to continue” is displayed. Press
to return to program or monitor mode.
If this does not correct the problem, contact
Reliance Electric for assistance.
Fatal Error The OIM did not pass
self-diagnostics.
Cycle drive power. If this does not correct the
problem, contact Reliance Electric for
assistance.
Fatal Regulator
Failure There is a problem with the drive. Cycle drive power. If this does not correct the
problem, contact Reliance Electric for
assistance.