Rockwell Automation WebPak 3000 User Guide - Manual (Page 51)

Using Quick Start 5-15
MOTOR HOT FLD AMPS
(P.510)
Sets the motor
nameplate value of
the rated hot field
amps. This input is
the basis of field
current scaling. Parameter Range: 0.11 to INSTALLED SUPPLY RATING (4.00, 10.00, or
20.00 AMPS )
Default Setting: 0.01 AMPS
Parameter Type: Configurable
If the factory defaults are restored, or if a valid value has not yet been entered for
this parameter, the DC field voltage is fixed at 150 V on a 230VAC line, or at 300V
on a 460VAC line.
!
ATTENTION: The incorrect configuration of MOTOR HOT FLD AMPS (P.510)
can cause a motor overvoltage condition. Configure MOTOR HOT FLD AMPS
to the motor’s nameplate value. Failure to observe this precaution can
result in bodily injury and damage to the equipment.