Rockwell Automation WebPak 3000 User Guide - Manual (Page 86)

Index-2 WebPak 3000 OIM User Guide
J
JOG ACCEL / DECEL TIME (P.013), 5-13
JOG key, 2-4, 6-5
JOG SPEED (P.012), 5-13
jogging drive, 6-4
K
key
arrow, 2-3
CANCEL , 2-2
CONTROL SOURCE SELECT , 2-4
ENTER , 2-3
FAULT , 2-2
HELP , 2-2
indicators, 2-7
JOG , 2-4, 6-5
PROGRAM / MONITOR , 2-2
RUN , 2-4, 6-4
STOP / RESET , 2-4, 6-5
keypad, 2-1
KEYPAD , control source, 6-3
keys
control, 2-4
programming, 2-2
L
language, changing, 3-3
link failure, 7-7
logs, fault and alarm, 7-3
M
Main Menu, 4-2
manual
hardware, 1-1
software, 1-1
MAXIMUM SPEED (P.004), 5-13
memory
operations, 4-9
restore, 4-9
save, 4-9
menu structure, A-1
menus, accessing, 4-2
message, clearing error, 7-7
MINIMUM SPEED (P.003), 5-12
monitor
drive outputs, 6-1
mode, help, 6-2
outputs, selecting, 6-2
motor data, 5-1
MOTOR HOT FLD AMPS (P.510), 5-15
MOTOR LOAD , 6-1
MOTOR RATED ARM AMPS (P.008), 5-9
MOTOR RATED ARM VOLTS (P.009), 5-9
MOTOR SPEED , 6-1
N
NEGATIVE CURRENT LIM (P.006), 5-14
NETWORK , control source, 6-3
non-retentive (parameter type), 4-1
NORMALIZED INDUCTANCE , 5-6
NORMALIZED INERTIA (P.222), 5-4, 5-6
O
OIM
failures, 7-7
replacing, 7-9
replacing circuit board, 7-8
Operator Interface Module ( OIM ), 1-1
output (parameter type), 4-1
outputs, monitoring, 6-1
selecting, 6-2
P
parameters, 1-1
accessing, 4-4
changing, 4-5
code numbers for, 3-3
defaults, restoring, 4-9
entry screen, 4-5
password, 4-7
quick start, 5-8
restoring, 4-9
saving, 4-9
self-tune, 5-7
types, 4-1
unchangeable, 4-7
values, restoring, 4-9
values, saving, 4-9, 4-10
viewing, 4-5
password, configuring, 4-7
phone, Reliance, 1-1
POSITIVE CURRENT LIM (P.005), 5-14
power, 3-1
program protection, 4-7
PROGRAM / MONITOR key, 2-2
programming error message, 7-7