Rockwell Automation GV3000/SE AC Bookshelf Drive Hardware Ref, Installation, and Troubleshooting User Manual
Page 50
6-2
GV3000/SE AC Bookshelf Drive Hardware Reference, Version 6.06
Step 2. Connect the three-phase AC output power motor leads to terminals U, V, and
W.
Step 3. Tighten the three-phase AC output power terminals to 1.4 Nm (12 in-lb).
!
ATTENTION: Do not route signal and control wiring with power wiring in
the same conduit. This can cause interference with drive operation.
Failure to observe these precautions could result in damage to, or
destruction of, the equipment
ATTENTION: Unused wires in conduit must be grounded at both ends
to avoid a possible shock hazard caused by induced voltages. Also, if a
drive sharing a conduit is being serviced or installed, all drives using this
conduit should be disabled to eliminate the possible shock hazard from
cross-coupled motor leads. Failure to observe these precautions could
result in bodily injury.