Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions User Manual
Page 24
Advertising
24
Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 1 Install a 1756 EtherNet/IP Communication Module
Set the Network IP Address with the Studio 5000 Environment
Follow these steps to use the Studio 5000 environment to set the communication
module’s IP address.
1. In the Controller Organizer, right-click the EtherNet/IP module and
choose Properties.
The Module Properties dialog box appears.
2. Click the Port Configuration tab.
3. In the IP Address field, type the IP address.
4. In the other fields, type the other network parameters, if needed.
5. Click Set.
6. Click OK.
IMPORTANT
The fields that appear vary from one EtherNet/IP module to another.
Advertising