Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 60)

60 Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 3 Install a 1769 EtherNet/IP Adapter
You can use these tools to set the network Internet Protocol (IP) address on your
1769 EtherNet/IP adapter:
• Bootstrap Protocol (BOOTP)/Dynamic Host Configuration Protocol
(DHCP) server - available out-of box
• RSLinx Classic software - only available for previously-configured
adapters
• Studio 5000 Logix Designer application, version 20.00.00 or later -
only available for previously-configured adapters
The module uses these tools sequentially to set the IP address.
The 1769 EtherNet/IP adapters are shipped with BOOTP/DHCP enabled.
This graphic shows the process used to set your module’s IP address.
Figure 3 - How Your Module’s IP Address is Set
If you need to reset your module’s settings to its factory default settings during
normal module operation, see
Reset the IP Address to a Factory Default Value on
page 67 .
Module Powerup
Module has an IP address.
Switches set
from
001…254? Yes No
Is DHCP or
BOOTP
enabled?
Yes No
Module requests
address from DHCP/
BOOTP server. Module uses IP address
stored in nonvolatile
memory.