Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 47)

Rockwell Automation Publication ENET-IN002F-EN-P - January 2014 47
Install a 1768 EtherNet/IP Communication Module Chapter 2
Mount on a DIN Rail
Follow these steps to install the module on a DIN rail.
1. Mount the DIN rail in a suitable location.
2. Open the DIN rail latches on the module.
3. Align and press the module onto the DIN rail to the left of the controller.
4. Slide the module snugly against the controller.
ATTENTION: This product is grounded through the DIN rail to chassis
ground. Use zinc-plated yellow-chromate steel DIN rail to assure proper
grounding. The use of other DIN rail materials (for example, aluminum
or plastic) that can corrode, oxidize, or are poor conductors, can result in
improper or intermittent grounding. Secure DIN rail to mounting
surface approximately every 200 mm (7.87 in.) and use end-anchors
appropriately.
31597-M