Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 45)

Rockwell Automation Publication ENET-IN002F-EN-P - January 2014 45
Install a 1768 EtherNet/IP Communication Module Chapter 2
Set the Network IP Address with the Studio 5000 Environment
Follow these steps to use the Logix Designer application from the Studio 5000
environment to set the communication module’s IP address.
1. In the Controller Organizer, right-click the EtherNet/IP module and
choose Properties.
The Module Properties dialog box appears.
2. Click the Port Configuration tab.
3. In the IP Address field, type the IP address.
4. In the other fields, type the other network parameters, if needed.
5. Click Apply.
6. Click OK.
IMPORTANT The fields that appear vary between EtherNet/IP communication
modules.