Wire the module, Use the following information to wire the module – Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions User Manual
Page 26
26
Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 1 Install a 1756 EtherNet/IP Communication Module
7. Align the circuit board with top and bottom guides in the chassis.
8. Slide the module into the chassis.
Make sure the module backplane connector properly connects to the
chassis backplane. Note that the module is properly installed when it is
flush with the power supply or other installed modules.
Wire the Module
Use the following information to wire the module.
Connect the Module to an EtherNet/IP Network via an RJ45
Connection
These 1756 EtherNet/IP communication modules use an RJ45 connector to
connect to an EtherNet/IP network:
• 1756-ENBT - ControlLogix EtherNet/IP bridge module
• 1756-EN2T - ControlLogix EtherNet/IP bridge module
• 1756-EN2TSC- ControlLogix EtherNet/IP Secure Communication
module
32455