Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 85)

Rockwell Automation Publication ENET-IN002F-EN-P - January 2014 85
USB Communication Chapter 5
Set Up a USB Driver
To configure RSLinx Classic software to use a USB port, you need to first set up a
USB driver. To set up a USB driver, follow these steps.
1. With one end installed in the computer, install a USB cable in your
communication module’s USB port.
The RSLinx Found New Hardware Wizard dialog box appears.
2. Click Install the software automatically (recommended).
3. Click Next.