Reset the ip address to a factory default value – Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions User Manual
Page 67
Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
67
Install a 1769 EtherNet/IP Adapter Chapter 3
Set the Network IP Address with the Studio 5000 Environment
Complete these steps to use the Logix Designer application to set the adapter’s IP
address.
1. In the Controller Organizer, right-click the EtherNet/IP module and
choose Properties.
The Module Properties dialog box appears.
2. Click the Port Configuration tab.
3. In the IP Address field, type the IP address.
4. In the other fields, type the other network parameters, if needed.
5. Click Apply.
6. Click OK.
Reset the IP Address to a Factory Default Value
You can reset the adapter’s IP address to its factory default value by sending a
MSG instruction to the module.
For more information on resetting the network IP address to its default value
with a MSG instruction, see Knowledgebase Answer ID 55362, at
(login required).