Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 34)

34 Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 1 Install a 1756 EtherNet/IP Communication Module
Follow these steps to remove or replace the module.
1. Push on the upper and lower module tabs to disengage them.
2. Slide the module out of the chassis.
IMPORTANT If you want to replace an existing module with an identical one, and you want
to resume identical system operation, you must install the new module in the
same slot and assign the same network configuration.
32460
32461