Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 28)

28 Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
Chapter 1 Install a 1756 EtherNet/IP Communication Module
Connect the Module to an EtherNet/IP Network via a Fiber Connector
The 1756-EN2F ControlLogix EtherNet/IP module uses a fiber connector to
connect to an EtherNet/IP network.
Attach the LC2 multi-mode fiber cable to the Ethernet port on the bottom of the
module as shown.
ATTENTION: Do not look directly into the optical port. Under certain
conditions, viewing the optical port may expose the eye to hazard. When
viewed under some conditions, the optical port may expose the eye beyond
the maximum permissible exposure recommendations.
Class 1 laser product. Laser radiation is present when the system is open and
interlocks bypassed. Only trained and qualified personnel should be allowed to
install, replace, or service this equipment.