Download the add-on profile – Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions User Manual
Page 49
Rockwell Automation Publication ENET-IN002F-EN-P - January 2014
49
Install a 1768 EtherNet/IP Communication Module Chapter 2
1. Attach the cable with the RJ45 connector to the Ethernet port on the
bottom of the module as shown.
2. Attach the other end of the cable to the devices in your network.
Download the Add-on Profile
If a module has a later firmware revision for the communication module than
recognized in the most current version of the Logix Designer application, you
need to download the Add-on Profile (AOP) for the communication module so
it can be recognized in the Controller Organizer.
Complete these steps to download and install an AOP.
1. Go to the Rockwell Automation Web site at
2. From the Support tab, choose Product Compatibility & Download
Center.
3. On the Get Downloads tab, click Find Product Downloads.
4. Enter the catalog number and click Go.
5. Select the module from the list then click the Find Downloads button at
the bottom of the Selections tab.