Rockwell Automation 1756-Enxxx_Ewxxx EtherNet/IP Modules Installation Instructions - Manual (Page 39)

Rockwell Automation Publication ENET-IN002F-EN-P - January 2014 39
Install a 1768 EtherNet/IP Communication Module Chapter 2
This graphic shows the process used to set your module’s IP address.
Figure 2 - How Your Module’s IP Address is Set
If you need to reset your module’s settings to factory default settings during
normal module operation, see
Reset the Module IP Address to a Factory Default
Value on page 46 .
These tools are used in this sequence to set the network IP address.
1. Set the Network IP Address with a BOOTP/DHCP Server .
2. Set the Network IP Address with RSLinx Software or the Studio 5000
Environment
.
Module Powerup
Module has an IP
address.
Is DHCP or
BOOTP
enabled?
Yes No
Module requests
address from DHCP/
BOOTP server. Adapter uses IP address
stored in nonvolatile
memory.